LOWINTENSITY ITM GENERATOR. --------------------------- A lowintensity ITM generator is a device who are used to investigate the effect of different frequency pictures at naturelaws and matter inside a weak to moderate orgon field. The orgon field is modulated by magnetic injection. The inner part of the generator is a box made of metal. Inside this box the injection coils are mounted 90 degree out from the metal wall. The coils are winded around orgonactive materials. In a typical generator there are between 20 and 50 coils. This coils are arranged geometrically to each other after a empiric structure. In the middle of this box are the scientific instruments placed. These instruments are used to measure the ITM effect on naturelaws and matter. On the outside of this box it's welded several profiles. On this profiles are mounted several power transistors or power operational amplifiers. This units are used for currentamplification to the coils inside the box. Outside the profiles are there water tubes. This is the cooling system. This entire structure are placed inside the orgon insulating material (glaswool). Outside this is a wood construction.Outside the wood construction is there a new layer with insulating material. Outside this is a new box of metal. Outside the second metal box is there a new insulating layer. Outside this is there finally a box made of wood. The insulating material also insulate heat. Without the cooling system the inner temperature would be high enough to destroy the power transistors. At the centre of the construction is there a probe who measures the total frequency picture inside the inner metal box. This sensor is used to control the power and effect to each coil. One will know immediately if one of the injection coils fail. The sensor is also used as a receiver for storing the frequency parameters for creating of frequency pictures who had positive results. It's therefore easy to recreate this frequency pictures in later experiments. This probe is also used to register new frequencies inside this box who are created by interaction between the other frequencies. The third task of this sensor is to investigate the effects on magnetic fields in energy making experiments based on ITM. On the transistor profiles are there mounted temperature sensors who keep an eye on the efficiency of the cooling system. The cooling is done by a stream of cold water trough the water tubes. The generator needs approximate 2000 Watt electrical power at the maximum setting.